/* $OpenBSD: if_lereg.h,v 1.9 2007/05/25 21:27:15 krw Exp $ */ /*- * Copyright (c) 1982, 1992, 1993 * The Regents of the University of California. All rights reserved. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * 3. Neither the name of the University nor the names of its contributors * may be used to endorse or promote products derived from this software * without specific prior written permission. * * THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE * ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF * SUCH DAMAGE. * * @(#)if_lereg.h 8.2 (Berkeley) 10/30/93 */ #define LEMEMSIZE 0x4000 /* * LANCE registers. */ struct lereg1 { volatile u_int16_t ler1_rdp; /* data port */ volatile u_int16_t ler1_rap; /* register select port */ }; #define VLEMEMSIZE 0x00040000 #define VLEMEMBASE 0xfd6c0000 /* * LANCE registers for MVME376 */ struct vlereg1 { volatile u_int16_t ler1_csr; /* board control/status register */ volatile u_int16_t ler1_vec; /* interrupt vector register */ volatile u_int16_t ler1_rdp; /* data port */ volatile u_int16_t ler1_rap; /* register select port */ volatile u_int16_t ler1_ear; /* ethernet address register */ }; #define NVRAM_EN 0x0008 /* NVRAM enable bit */ #define INTR_EN 0x0010 /* Interrupt enable bit */ #define PARITYB 0x0020 /* Parity clear bit */ #define HW_RS 0x0040 /* Hardware reset bit */ #define SYSFAILB 0x0080 /* SYSFAIL bit */ #define NVRAM_RWEL 0xE0 /* Reset write enable latch */ #define NVRAM_STO 0x60 /* Store ram to eeprom */ #define NVRAM_SLP 0xA0 /* Novram into low power mode */ #define NVRAM_WRITE 0x20 /* Writes word from location x */ #define NVRAM_SWEL 0xC0 /* Set write enable latch */ #define NVRAM_RCL 0x40 /* Recall eeprom data into ram */ #define NVRAM_READ 0x00 /* Reads word from location x */ #define CDELAY delay(10000) #define WRITE_CSR_OR(x) reg1->ler1_csr=((struct le_softc *)sc)->csr|=x #define WRITE_CSR_AND(x) reg1->ler1_csr=((struct le_softc *)sc)->csr&=x #define ENABLE_NVRAM WRITE_CSR_AND(~NVRAM_EN) #define DISABLE_NVRAM WRITE_CSR_OR(NVRAM_EN) #define ENABLE_INTR WRITE_CSR_AND(~INTR_EN) #define DISABLE_INTR WRITE_CSR_OR(INTR_EN) #define RESET_HW WRITE_CSR_AND(~0xFF00);WRITE_CSR_AND(~HW_RS);CDELAY #define SET_IPL(x) WRITE_CSR_AND(~x) #define SET_VEC(x) reg1->ler1_vec=0;reg1->ler1_vec |=x; #define PARITY_CL WRITE_CSR_AND(~PARITYB) #define SYSFAIL_CL WRITE_CSR_AND(~SYSFAILB) #define NVRAM_CMD(c,a) for(i=0;i<8;i++){ \ reg1->ler1_ear=((c|(a<<1))>>i); \ CDELAY; \ } \ CDELAY;