Annotation of sys/dev/ic/i8253reg.h, Revision 1.1
1.1 ! nbrk 1: /* $OpenBSD: i8253reg.h,v 1.3 2003/06/02 23:28:02 millert Exp $ */
! 2: /* $NetBSD: i8253reg.h,v 1.5 1998/01/19 11:38:00 drochner Exp $ */
! 3:
! 4: /*-
! 5: * Copyright (c) 1993 The Regents of the University of California.
! 6: * All rights reserved.
! 7: *
! 8: * Redistribution and use in source and binary forms, with or without
! 9: * modification, are permitted provided that the following conditions
! 10: * are met:
! 11: * 1. Redistributions of source code must retain the above copyright
! 12: * notice, this list of conditions and the following disclaimer.
! 13: * 2. Redistributions in binary form must reproduce the above copyright
! 14: * notice, this list of conditions and the following disclaimer in the
! 15: * documentation and/or other materials provided with the distribution.
! 16: * 3. Neither the name of the University nor the names of its contributors
! 17: * may be used to endorse or promote products derived from this software
! 18: * without specific prior written permission.
! 19: *
! 20: * THIS SOFTWARE IS PROVIDED BY THE REGENTS AND CONTRIBUTORS ``AS IS'' AND
! 21: * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
! 22: * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
! 23: * ARE DISCLAIMED. IN NO EVENT SHALL THE REGENTS OR CONTRIBUTORS BE LIABLE
! 24: * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
! 25: * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
! 26: * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
! 27: * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
! 28: * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
! 29: * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
! 30: * SUCH DAMAGE.
! 31: */
! 32:
! 33: /*
! 34: * Register definitions for the Intel 8253 Programmable Interval Timer.
! 35: *
! 36: * This chip has three independent 16-bit down counters that can be
! 37: * read on the fly. There are three mode registers and three countdown
! 38: * registers. The countdown registers are addressed directly, via the
! 39: * first three I/O ports. The three mode registers are accessed via
! 40: * the fourth I/O port, with two bits in the mode byte indicating the
! 41: * register. (Why are hardware interfaces always so braindead?).
! 42: *
! 43: * To write a value into the countdown register, the mode register
! 44: * is first programmed with a command indicating which byte of
! 45: * the two byte register is to be modified. The three possibilities
! 46: * are load msb (TMR_MR_MSB), load lsb (TMR_MR_LSB), or load lsb then
! 47: * msb (TMR_MR_BOTH).
! 48: *
! 49: * To read the current value ("on the fly") from the countdown register,
! 50: * you write a "latch" command into the mode register, then read the stable
! 51: * value from the corresponding I/O port. For example, you write
! 52: * TMR_MR_LATCH into the corresponding mode register. Presumably,
! 53: * after doing this, a write operation to the I/O port would result
! 54: * in undefined behavior (but hopefully not fry the chip).
! 55: * Reading in this manner has no side effects.
! 56: *
! 57: * The outputs of the three timers are connected as follows:
! 58: *
! 59: * timer 0 -> irq 0
! 60: * timer 1 -> dma chan 0 (for dram refresh)
! 61: * timer 2 -> speaker (via keyboard controller)
! 62: *
! 63: * Timer 0 is used to call hardclock.
! 64: * Timer 2 is used to generate console beeps.
! 65: */
! 66:
! 67: /*
! 68: * Frequency of all three count-down timers; (TIMER_FREQ/freq) is the
! 69: * appropriate count to generate a frequency of freq hz.
! 70: */
! 71: #ifndef TIMER_FREQ
! 72: #define TIMER_FREQ 1193182
! 73: #endif
! 74: #define TIMER_DIV(x) ((TIMER_FREQ+(x)/2)/(x))
! 75:
! 76: /*
! 77: * Macros for specifying values to be written into a mode register.
! 78: */
! 79: #define TIMER_CNTR0 0 /* timer 0 counter port */
! 80: #define TIMER_CNTR1 1 /* timer 1 counter port */
! 81: #define TIMER_CNTR2 2 /* timer 2 counter port */
! 82: #define TIMER_MODE 3 /* timer mode port */
! 83: #define TIMER_SEL0 0x00 /* select counter 0 */
! 84: #define TIMER_SEL1 0x40 /* select counter 1 */
! 85: #define TIMER_SEL2 0x80 /* select counter 2 */
! 86: #define TIMER_INTTC 0x00 /* mode 0, intr on terminal cnt */
! 87: #define TIMER_ONESHOT 0x02 /* mode 1, one shot */
! 88: #define TIMER_RATEGEN 0x04 /* mode 2, rate generator */
! 89: #define TIMER_SQWAVE 0x06 /* mode 3, square wave */
! 90: #define TIMER_SWSTROBE 0x08 /* mode 4, s/w triggered strobe */
! 91: #define TIMER_HWSTROBE 0x0a /* mode 5, h/w triggered strobe */
! 92: #define TIMER_LATCH 0x00 /* latch counter for reading */
! 93: #define TIMER_LSB 0x10 /* r/w counter LSB */
! 94: #define TIMER_MSB 0x20 /* r/w counter MSB */
! 95: #define TIMER_16BIT 0x30 /* r/w counter 16 bits, LSB first */
! 96: #define TIMER_BCD 0x01 /* count in BCD */
! 97:
CVSweb